User's Manual

23
22
Before using iCube to fit a client with hearing
instruments, make sure the battery is sufficiently
charged. Remove iCube from the iCube charger
and turn it ON.
Wearing iCube
Open the neckloop by unplugging the jack, and place
iCube around your client’s neck as shown below.
(Re)connecting the neckloop
will activate the built-in
antenna and enable iCube to
operate correctly.
Using iCube
Detecting and programming hearing instruments
In wireless fitting, where there are no left and right
fitting cables, the assignment of left/right is done via
the fitting application.
Click the “Detect” button which is located on the
toolbar and in the “Instrument Selection” screen to
identify the hearing instruments.
Follow the iPFG instructions to assign (or reassign) each
hearing instrument to the desired side (left or right).
GA_iCube_GB._AK1_9.10.07.qxp 24.1.2008 14:27 Uhr Seite 22