User's Manual

8
Installing and using the iCube charger
Install the iCube charger by plugging the power
supply into a power outlet and docking iCube into the
iCube charger as shown below.
It is recommended that you use the iCube charger to
store and charge iCube whenever it is not in use.
This way it will be sufficiently charged and ready for
the next fitting session.
Getting started
9
Charging the battery
Your iCube has an internal, rechargeable battery.
As soon as you place your iCube on the iCube charger,
the battery starts charging.
For safety reasons, recharge the battery only with
chargers supplied by Phonak.
During the charging process, the battery indicator is
lit solid. Once the battery is fully charged, the battery
indicator will start flashing slowly. Normally, charging
an empty battery takes about 90 minutes. It is safe
to leave the charger connected overnight — the battery
cannot be overcharged.
When charging your iCube for the first time,
leave it to charge for at least three hours (even
if the battery indicator starts flashing earlier).
A new battery’s full performance is achieved only
after two or three complete charge and discharge
cycles.
iCube
GA_iCube_GB._AK1_9.10.07.qxp 24.1.2008 14:27 Uhr Seite 8