User's Manual

large area antenna
6
19 tuning ring
Do not deform or move this ring,
or you may affect the antenna's
tuning and efficiency
21 mounting hole/set screw
Use to mount on a tripod with a mast.
Ground your mounting pole, tripod, or
other holder to a metal surface. You may
also hang the antenna from a railing or
metal superstructure (such as in a stadium).
! warning
The antenna is an electrical conduc-
tor. Contact with power lines can
result in death or serious injury. Do
not install the antenna, supporting
mast, or tower where there is any
possibility of contact with a high-
voltage arc from power cables or
service drops. Outdoor antennas
should be grounded against light-
ning strikes. Consult the National
Electrical Code for further details.
20 worm clamps
Loosen both clamps; extend the large
center section to the black ring; tighten
lower clamp; extend the smaller element
to the black ring; tighten the top clamp
19
21
20
20
The large area antenna is only available
with a specially tuned version of the
560T (model # PE560T-LA). This is
done to insure the system meets FCC
and Industry Canada Requirements.
This antenna should only be installed
by a qualified sound contractor or fac-
tory trained professional.
3839 OnWave User Guide 1/18/05 12:48 PM Page 10