User's Manual

22
F. LED light: Default is steady ON. Choose blink or disable (off). Use ▲ ▼ to navigate
and change selection, then press SYNC. When fi nished, press ◄ to save and exit.
G. Beep tone: Use ▲ ▼ to choose the frequency/tone of the beep and press SYNC to
save selection. When fi nished, press ◄ to save and exit.
H. Beep vol: Change the loudness level of the beep tone or disable the beep (off). Use ▲
▼ to navigate and press SYNC to save selection. When fi nished, press ◄ to save and
exit.
I. Default Channel (R1 only): Choose the default channel for the receiver when it is
turned on. The default is ”last channel used”. Use ▲ ▼ to navigate and press SYNC
to make selection. When fi nished, press ◄ to save, and exit.
J. Channel button (R2 only): Choose enable or disable, press SYNC to save then press
the ◄ button to save and exit.
K. Channel set: The Default is Select All. To select discrete channels, choose CLEAR
ALL (use SYNC button) then scroll ▲ ▼ to the desired channel and press SYNC for
each channel. When fi nished, press ◄ to save and exit.