Hardware Owner manual

ManualsBrandsPhotoflex ManualsPhoto AccessoriesLP-SWVLHRDWR LitePanel

PROFESSIONAL PHOTOGEAR

Visit photoexlightingschool.com® for the best free learning resource!

For detailed specifications, product tutorial videos and more, please visit www.photoflex.com®

LitePanel

™

Mounting Hardware Instruction Manual • Item: LP-SWVLHRDWR

LitePanel Mounting Hardware

The LitePanel Swivel Mount Hardware is designed to interface

the LitePanel line of frames with the LiteReach Plus

handheld

extension or the appropriate Photoex LiteStand

Before assembly check to make sure you have all of the

following parts

• 1ea. Swivel Stand Mount

• 1ea. Upper Cover

• 1ea. Lower track mount

• 2ea. 6mm / .75 x 10mm Socket head screws

• 1ea. 3/16”/5mm allen wrench

Attaching the LitePanel Mounting Hardware to LitePanel

Frames:

Note: You should have the assembled LitePanel frame lying on a

at surface

Step 1 Disassemble the upper cover from the lower track mount

using the allen wrench. Figure 1

Note: There are two mounting options for the LitePanel Mounting

Hardware depending on your application:

A. If you are using the hardware with the LiteReach Plus

extension pole then you will only use one LitePanel hardware set.

The orientation of the lower track plate will have the swivel track

in a 90 degree position in relation to the frame tube. Figure 2

B. If you are using the LitePanel hardware with two light stands

to mount the LitePanel overhead, two LitePanel hardware sets

will be required. The orientation of the lower track plate will have

the swivel track in a parallel position in relation to the frame tube.

Figure 3

Note: For most applications it is recommended that you attach

the hardware in the middle of the width of the frame for the best

balance and stability.

Step 2 Place the track plate under the frame tube, making sure

the swivel track is in the desired position. Figure 4

Step 3 Place the Top Cover over the frame tube aligning the

holes with the lower Track plate for the attachment screws.

Figure 5

Step 4 Attach the top cover to the lower track plate by securely

tightening both socket screws using the Allen wrench. Figure 6

Figure 2.

Swivel Stand

Mount

Upper Cover

Lower Track

Mount

Socket Head Screws

Allen Wrench

Figure 1.

Figure 3.

Figure 5. Figure 6.

Figure 4.

Rev 07/10/13

Summary of content (2 pages)

PAGE 1
LitePanel™ Mounting Hardware Instruction Manual • Item: LP-SWVLHRDWR Socket Head Screws LitePanel Mounting Hardware The LitePanel Swivel Mount Hardware is designed to interface the LitePanel line of frames with the LiteReach Plus® handheld extension or the appropriate Photoflex LiteStand ® . Upper Cover Lower Track Mount Allen Wrench Before assembly check to make sure you have all of the following parts • 1ea. Swivel Stand Mount • 1ea. Upper Cover Swivel Stand Mount • 1ea. Lower track mount • 2ea.
PAGE 2
Alternatively, the hardware can be attached so that the track plate is facing out from the edge of the frame. In this configuration, a second fabric can be attached on the opposite side for a quick change of reflector surfaces or for double diffusion. Figure 7 Step 5 With either one or two upper and lower components attached to the frame. Slide the swivel stand mount onto the swivel track on the lower plate and tighten the set screw knob. Figures 8-9 Figure 7. Figure 8.