User's Manual

7
2. Connect a compatible cable to the Phottix
Atlas II Flash in/out port or Flash out port.
3. Connect the opposite end of the cable to the
ash or studio strobe (A 6.3 mm adaptor is
included for studio strobes with larger ports).
4. Set the Transmit / Receive Mode Switch on
the Atlas II to Rx (receive mode).
5. Turn on the ash/strobe, Phottix Atlas II and
camera.
6. Set the ash/strobe to Manual mode.
* It is not unusual for the ash to discharge
once after turning on the Phottix Atlas II.
Connecting a local ash on a
bracket
(The Atlas II will trigger a local ash on
a bracket and a remote manual
ash/strobe equipped with a Phottix
Atlas II)
En
INSTRUCTION MANUAL
1. Turn o the camera, ash/strobe and the
Phottix Atlas II transceiver.
2. Mount a Phottix Atlas II in the camera’ s hot
shoe port.
3. Connect a compatible cable to the Phottix
Atlas II Flash in/out port or Flash out port.
4. Connect the opposite end of the cable to the
ash’s PC Sync port.
5. Set the Transmit / Receive Mode Switch on
the Atlas II to Tx (transmit mode).