User's Manual

When the recycling of all the flash units is completed, the master units’ charge lamp
lights on.
1.6 Check the operation: Press the master unit’s test flash button (charge lamp). The
slave unit flash will fire. If no, check that it is placed within the operation range.
1.7 Take the picture: Set the camera and take the picture, in the same way as with
normal flash shooting. If a standard flash exposure was obtained, the flash exposure
confirmation lamp lights up (blue) for 2 sec.
2. Autoflash Shooting Using Multiple Slave Unit
When you need more flash output you can increase the number of slave units and fire
them as a single flash. To add slave units, use the same procedure as “ Autoflash
Shooting Using One Slave Unit”. Set A, B or C as the firing group. The flash will not
fire if it is set to D or E. When the number of the slave units is increased, automatic
control is performed to fire all flashes at the same flash output and ensure that the
total flash output results in standard exposure.
Using Fully Automatic Wireless Flash
Flash exposure compensation and other settings set on the Phottix Laso transmitter
(master unit) will be automatically set in the flash (slave). You don’t need to operate
the slave unit.
1. Flash Exposure Compensation
In the same way as normal exposure compensation, you can set exposure
compensation for flash. The flash exposure compensation amount can be set up to ±3
stops in 1/3-stop increments.
1. Press function button 4 until
is displayed.
2. Press function button 2 corresponding to
, is
displayed and flash compensation amount is
highlighted.
3. Set the flash compensation amount: turn< > to set
the flash compensation amount, and press < >button.
4. ”0.3” indicates 1/3 stops, and”0.7”indicates 2/3 stops
5. To cancel flash exposure compensation, return the
compensation amount to “±0”.
Note:
1. By setting C.Fn13, you can choose to set the flash compensation amount by