User Guide

4
En
INSTRUCTION MANUAL
D and E) of receivers which are set to the same channel, and have the same
Digital ID setting. (Unless the group is set to OFF on the TCU).
Adjusting Channel, Group and Digital ID on the TCU
The channel, group and ID number of the TCU can be set in Odin II Menu.
Please see Menu functions below.
Adjusting Channel, Group and Digital ID on the Receiver
1. To set Channels on the Receiver
2. Press
2.button, when the channel indicator on the LCD screen ashes.
3. Press
or button to set the channel.
4. Press
button to exit.
To set Group setting on the Receiver
1. Press button, when the group indicator on the LCD screen ashes.
2. Press selection button
or to set group.
3. Press
button to exit.
To set the Digital ID number on the Receiver
1. Press
button.
2. Press selection button
or to adjust the ID value.
3. Press the ID (insert graphic) button to advance to the next digit.
4. Repeat until a four digit code is set.
5. Press
to exit setting mode
Please note: When the Odin II is set to channels (1,2,3,4) it is compatible with
Odin I receivers and Mitros+ ashes. When set to these channels the Odin II
TCU will only control group A, B and C (like the Odin I TCU). Group D and E will
not be displayed on the TCU and the Digital ID Function is not available when
using Channels 1-4.
Odin II Display
TCU
The TCU has two operating modes: Mixed TTL/M mode and
Ratio mode.
The Mixed TTL/M Mode (channels 5-32):
Flash Exposure
Compensation
Flash Exposure
Compensation
High Speed Sync
: Enabled
Blank: Disabled
7.AF Asist Light:
: Enabled
Blank: Disabled
Battery Level
Display
Groups
Flash Output
Flash Mode :
TTL, M, OFF
Channel: 05~32
The Mixed TTL/M Mode(channels 1-4)
:
Channel: 01~04
Ratio mode
Flash Ratio
: ZOOM Level
Adjustment in active
(20-200mm)
: Modeling Light
Adjustment in active (0-9)
Blank: Zoom Level/
Modeling Light
Adjustment Inactivated
Receiver
Group: A, B,C,D,E Battery Level Display
Channel: 01-32
Digital ID:
0000~9999
Digital ID selected
Flash and Receiver Communication
： In Communication
Blank: Out of communication
Functions and Operations
TCU Modes
In Mixed TTL/M mode groups A, B, C, D and E can be set to TTL, Manual (M) or
Turned-O. EV or power levels can also be adjusted.
The ratio mode is similar to the original Nikon TTL system, The ratio of groups A
and B can be set from 8:1 to 1:8. EV levels can also be adjusted.
Setting the Operating Mode
Press
button of the TCU to change between Mixed TTL/M mode and Ratio
mode.