Installation & Assembly

INSTALLATION INSTRUCTIONS FOR LAVATORY FAUCETS

WITH A DRY TEE FLUSH MOUNTED VALVE

1 3/8"

DIAMETER.

HOLE

for HOT &

COLD VALVE

MIN. 1 3/8" DIAMETER

SPOUT HOLE

Should a counter top need to be drilled, please reference

the diagram above.

Install spout tee assembly (7) as shown in diagram.

Remove top fastening nut and washer (1) from the lavatory

valve. (NOTE A: All lever handle sets are supplied with one right-

hand valve and one left-hand valve. Install valve with blue dot

o the cold side [Round handle sets are supplied with two hot

valves that turn in the same direction]). Insert valve from below

through hole in lavatory or countertop.

Insert spout base nipple into center hole in lavatory or

counter top. Install stainless washer (5) nut (6) on spout

nipple and tighten. Place pop-up knob rod (8) through spout.

Reattach top fastening nut and washers (1).

Set valve to proper rough-in height “A”, by adjusting bottom -

fastening nut. Secure valve by tightening top fastening nut.

Repeat procedure for the second lavatory valve.

Step 1

Step 2

Step 3

Step 4

Step 5 Step 6

MIX BLADE

MIX RING

STRIA BLADE

MIX LEVER

MIX CUBE

STRIA LEVER

STRIA CUBE

3/4”

1/2”

PAGE 1
INSTALLATION INSTRUCTIONS FOR LAVATORY FAUCETS WITH A DRY TEE FLUSH MOUNTED VALVE Step 2 Step 1 1 3/8" DIAMETER. HOLE for HOT & COLD VALVE 8 MIN. 1 3/8" DIAMETER SPOUT HOLE 5 6 Should a counter top need to be drilled, please reference the diagram above. Insert spout base nipple into center hole in lavatory or counter top. Install stainless washer (5) nut (6) on spout nipple and tighten. Place pop-up knob rod (8) through spout.
PAGE 2
Step 7 Step 8 1-1/4” Hole Diameter 10 11 12 9 13 9 Connect stainless steel flex lines (9) from valve outlets to spout tee (7). Flex lines should be looped as shown in diagram. FLEX LINES MUST NOT BE KINKED. Adjust valves and or spout teeto eliminate any kinking in the flex lines. Install escutcheons onto the valves and hand tighten. DO NOT OVER-TIGHTEN. Install handles onto valve stems. Step 9 14 Insert drain rim (10) into the basin placing the Teflon washer (11) under the rim.
PAGE 3
5 6 1 7 8 2 3 9 4
PAGE 4
Limited Warranty This Limited Warranty is expressly in lieu of any other warranties, expressed or implied, arising by law or otherwise, including without limitation, any implied warranty of merchantability or fitness for a particular purpose. This Limited Warranty may not be altered, varied, or extended, except by a written instrument executed by Phylrich. The remedy or repair or replacement as provided under this Limited Warranty is exclusive.