INSTALLATION INSTRUCTIONS FOR LAVATORY FAUCETS WITH A TEE ASSEMBLY 1261 Logan Ave, Costa Mesa, CA 92626 Telephone: 714-361-4830 Fax: 714-617-3120 www.phylrich.
Step 1 Step 2 1 1/8" DIAMETER. HOLE for HOT & COLD VALVE 7 8 MIN. 1 1/2" DIAMETER SPOUT HOLE 14 Insert spout base nipple into center hole in lavatory or counter top. Install stainless washer (7) and spont (8) on spout nipple and tighten. Place pop-up knob rod (14) though spout. Should a counter top need to be drilled, please reference the diagram above. Step 3 Step 4 2 3 9 10 11 12 13 4 14 Remove top fastening nut and washer (2 & 3) from the lavatory valve.
Step 7 Step 8 25 26 27 28 6 29 6 Connect stainless steel flex lines (6) from valve outlets to spout tee (10). Flex lines should be looped as shown indiagram. FLEX LINES MUST NOT BE KINKED. Adjust valves and or spout tee to eliminate and kinking in the flex lines. Install escutcheons onto the valves and hand tighten. Do not over-tighten. Install handles onto valve stems Step 9 Insert drain rim (25) into the basin placing the Teflon washer (26) under the rim.
Page 3 P99030 (8/07)
ROUGH IN SPECIFICATIONS FOR LAVATORY SETS WITH TEE ASSEMBLIES Phylrich Prod# Rough In K101.....................2 K109.....................2 K110.....................2 K120.....................2 K120A..................2 K121.....................2 K121A..................2 K123.....................2 K137.....................2 K137SF................2 K141.....................2 K144.....................2 K158A..................2 K158B..................2 K158C..................2 K158D..................2 K158F..