User Manual

8 Defining Setup Options
Defining Setup Options
LIFEPAK 20e Defibrillator/Monitor Operating Instructions 8-11
©2006-2013 Physio-Control, Inc.
ALARMS SETUP MENU
The Alarms Setup menu allows you to define alarms and set the alarm volume level. When you
select a menu item, the screen displays a help message. The underlined options are factory
default settings.
PRINTER SETUP MENU
The Printer Setup menu allows you to define automatic event printing and ECG frequency
response. When you select a menu item, the screen displays a help message. The underlined
options are factory default settings.
Table 8-15 Alarms Setup Menu
Menu Item Help Message Options
VOLUME
Set volume for alarms, tones,
and voice prompts
Select volume level from gradient display.
The minimum setting reduces but does not
silence alarms.
ALARMS
Enable alarms at power up ON: Enables alarms for Heart Rate, SpO2,
and CO2 whenever defibrillator power is
turned on.
OFF: Alarms available through ALARMS
button.
VF/VT ALARM
Alarms when VF or VT
detected
ON: Enables VF/VT alarm whenever
defibrillator power is turned on.
OFF: VF/VT alarm available through
ALARMS button.
Table 8-16 Printer Setup Menu
Menu Item Help Message Options
AUTO PRINT
Specify Auto Print Event Refer to Table 8-17.
ECG MODE
Default ECG frequency
response
MONITOR or DIAGNOSTIC
MONITOR MODE
Default monitor frequency
response for printer and
display
1–30 HZ or .5–40 HZ.
DIAGNOSTIC MODE
Default diagnostic frequency
response for printer
.05–40 HZ or .05–150 HZ.
ALARM EVENTS
Print waveforms with alarm
events and print with
CODE SUMMARY report
ON or OFF.
EVENT
WAVEFORMS
Print waveforms with user-
entered events and print with
CODE SUMMARY report
ON or OFF.