User Manual

Appendix C
Screen Messages
LIFEPAK 20e Defibrillator/Monitor Operating Instructions C-5
©2006-2013 Physio-Control, Inc.
STAND CLEAR/PUSH
SHOCK BUTTON
Stand clear of the patient and push the SHOCK button.
START CPR
Initiate CPR in AED mode.
SWITCHING PRIMARY
TO LEAD II
PADDLES lead is not available and you pressed the ANALYZE button.
SWITCHING PRIMARY
TO PADDLES
PADDLES lead is available and you pressed the ANALYZE button.
TRANSMISSION
CANCELLED
Data transmission has been cancelled.
TRANSMISSION
COMPLETE
Data transmission completed successfully.
TRANSMISSION
FAILED
Data transmission was not successful.
UNABLE TO TRANSMIT
Unable to send data.
USE ECG LEADS
The device is attempting synchronized cardioversion and PADDLES
lead was selected.
USER TEST DID NOT
COMPLETE
Test plug not connected to QUIK-COMBO therapy cable, standard
paddles not seated in paddle wells, possible defective therapy cable,
or a problem with the defibrillator during user test.
USER TEST DID NOT
COMPLETE –
CONNECT TO TEST
PLUG
Test plug not connected to QUIK-COMBO therapy cable, standard
paddles not seated in paddle wells, defective therapy cable, or a
problem with the defibrillator during user test.
USER TEST FAILED
An unsuccessful user test has occurred.
USER TEST IN
PROGRESS
Confirms that the user test is in progress.
USER TEST
SUCCEEDED
A successful user test was completed.
XX% TRANSMITTED
Specified percent of the transmission is completed.
Table C-1 Summary of Screen Messages (Continued)
Message Description