User Manual

Docking Station

LIFEPAK 20e Defibrillator/Monitor Operating Instructions G-1

Appendix G

LIFEPAK 20E DEFIBRILLATOR/MONITOR DOCKING STATION

The LIFEPAK 20e defibrillator/monitor docking station allows you to secure your defibrillator to

an emergency cart or other flat surface. The docking station provides a 360-degree turning

radius for the viewing of the LIFEPAK 20e defibrillator/monitor display from any angle.

Note: The docking station cannot be used with the CodeManagement Module.

To insert the LIFEPAK 20e defibrillator/monitor into the docking station:

1 Hold the LIFEPAK 20e defibrillator/monitor by the handle over the docking station (refer to

Figure G-1, arrow 1).

2 Tilt the LIFEPAK 20e defibrillator/monitor backward into the docking station, aligning slots in

the rear of the defibrillator to rollers on the docking station (refer to Figure G-1, arrow 2).

3 Align recess in lower front panel of the LIFEPAK 20e defibrillator/monitor with the front roller

on the docking station and press down on the front of the LIFEPAK 20e defibrillator/monitor

until you hear a click (refer to Figure G-1, arrow 3).

4 Check to make sure that the LIFEPAK 20e defibrillator/monitor is securely locked into

position.

To turn the LIFEPAK 20e defibrillator/monitor while in the docking station:

1 Grasp the LIFEPAK 20e defibrillator/monitor by the handle, or by its sides.

2 Turn to the correct position. You will hear clicking sounds as the defibrillator locks into place.

Figure G-1 Docking Station

To remove the LIFEPAK 20e defibrillator/monitor from the docking station:

1 Grasp the LIFEPAK 20e defibrillator/monitor by the handle.

2 Pull briskly on the LIFEPAK 20e defibrillator/monitor until it releases from the docking station.

Note: To install the docking station to a flat surface or wall mount (GCX) bracket, refer to the

docking station installation instructions or consult the LIFEPAK 20e Defibrillator/Monitor

Service Manual.