Manual

ManualsBrandsPhysitemp Instruments ManualsSensorsBFS 60MP

ASSEMBLY AND OPERATING INSTRUCTIONS

BFS-60MP

CONTROLLER AND THERMOELECTRIC COOLING STAGE

Contents:

1. Contents of Box

2. Unpacking Instructions

3. Installation and Operating Instructions

4. Warranty and Service

PHYSITEMP INSTRUMENTS INC

154 Huron Ave

Clifton NJ 07013

1-800-452-8510

physitemp@aol.com

Summary of content (5 pages)

PAGE 1
ASSEMBLY AND OPERATING INSTRUCTIONS BFS-60MP CONTROLLER AND THERMOELECTRIC COOLING STAGE Contents: 1. Contents of Box 2. Unpacking Instructions 3. Installation and Operating Instructions 4. Warranty and Service PHYSITEMP INSTRUMENTS INC 154 Huron Ave Clifton NJ 07013 1-800-452-8510 physitemp@aol.
PAGE 2
1. Contents of Box 1. BFS60MP Thermoelectric Cooling Stage 2. Extension Water Tubes (2 - 5 foot long tubes with Male self-sealing connectors and 2 – 5 foot long tubes with Female self-sealing connectors to a Y adapter for laboratory tap water supply ) 3. BFS-60MP Control Unit 4. 110 VAC 20Amp Power cord 5. Instruction Manual 2. Unpacking Instructions Remove contents of carton and check all items in the contents list are present. Visually check that everything is in good condition.
PAGE 3
Attach the 110 VAC power cord to the socket on the rear of the controller and to a 20 amp AC outlet socket. Switch the power switch on the AC input module ‘ON’. The display on the front panel controller will read ‘8.8.8.8’ for several seconds to ensure that all display segments are operative. In order to set the stage operating temperature you must follow the instructions found on top of the controller. These instructions are reproduced below in the event that those on the controller become defaced.
PAGE 4
Before the surface of the stage freezes apply an ample amount of water/OCT/ sucrose solution to form a base onto which you can freeze your specimen. Once the specimen has become attached freezing will be facilitated by building a dam of liquid around the sides of the specimen to reduce heat losses from the specimen to the surroundings.
PAGE 5
4. Warranty and Service In the event that a system is to be returned for repair, please pack it carefully and send it prepaid to: SERVICE DEPARTMENT PHYSITEMP INSTRUMENTS, INC. 154 HURON AVENUE CLIFTON, N.J. 07013 Please include with the instrument: 1. A note describing any problems encountered. 2. The name and telephone number of a person we can contact. 3. The complete return address for shipping. WARRANTY Physitemp Inc.