User's Manual




2.2 Sensorinstallation
2.2.1 Upto40sensorscanconnecttoasingleHub.Themaximum
distancebetweenthesensorsandtheHubis80m.
2.2.2 Sensormustbeinstalledafterthehubwassuccessfully
installedandwhileinsensoracquiringmode.
2.2.3 Installthesensor:
● Dendrometer (Figure C1) ‐ Push the calibration spacer
devicetosettherightdistancebetweenthedendrometer
pistontipandthetreetrunk.Oncethetiphasbeen
pushedthesensorLEDwillstarkblinking,searchingfor
a hub.
 WaitfortheblinkingtostopandtheLEDto
becomesteady,anindicationthatthesensorhas
connectedtothehubandtheinstallationissuccessful.
● Fruitsensor(FigureC2)‐openthesensor's“claws”and
place them on the desired fruit.The LED on the sensor