Spec Sheet

ManualsBrandsPI Manufacturing ManualsVideo DistributionHDMI Extender Over Cat6 Cable with Built-in IR

PI MANUFACTURING

HDMI Extender Over

Cat6 Cable with

Built-in IR and EDID

Pass-Through

Product Features

- Extends HDMI and IR over a single Cat6 23AWG cable

- 1080p resolution at up to 164ft using Cat6 23AWG

cable

- Supports all HDMI features including 1080p Full HD,

deep color, lip sync, CEC and all multi-channel audio

formats, including Dolby Digital Plus, 7.1 LPCM, Dolby

TrueHD and DTS Master Audio

- Control devices via IR signal

- EDID pass-through

- Plug and play, no drivers required

- Metal housing for durability

PI Manufacturing, www.pimfg.com

HDMI-CAT6-60M Data Sheet

Summary of content (5 pages)

PAGE 1
PI MANUFACTURING Powered by Infinite Solutions HDMI Extender Over Cat6 Cable with Built-in IR and EDID Pass-Through HDMI-CAT6-60M Data Sheet Product Features - Extends HDMI and IR over a single Cat6 23AWG cable - 1080p resolution at up to 164ft using Cat6 23AWG cable - Supports all HDMI features including 1080p Full HD, deep color, lip sync, CEC and all multi-channel audio formats, including Dolby Digital Plus, 7.
PAGE 2
Product Features Overview Limited by the distance of HDMI cables and need a cost-effective way to extend the length of your HDMI cable? PI Manufacturing's HDMI extender extends HDMI signals up to 164 feet using Cat6 cables with support up to 1080p. Built-in EDID pass-through allows display capabilities to be communicated.
PAGE 3
EDID Pass-Through The HDMI-CAT6-60M supports EDID (Extended Display Identification Data) passthrough. This allows display capabilities to be communicated, providing optimal resolution when sending content from the HDMI source to the display. Source Display Video EDID Input Video Output EDID 1080p Full HD With support for resolutions up to 1080p / 60Hz, you're able to view your output in high definition. HDCP support also allows protected content to be effortlessly viewed without issues.
PAGE 4
Plug and Play Operation Setting up the HDMI extender is as easy as plugging in the HDMI source on the transmitter end and then plugging in the HDMI display on the receiver end. Plug in the included IR cables on both ends to allow the IR signal to be sent remotely, select the length of Cat6 or higher Ethernet 23AWG cable (up to 164 feet) to plug into the Ethernet port on both ends of the transmitter / receiver, and then plug in the included 5V 1A power adapters on both ends for operation.
PAGE 5
Specifications Power DC5V 1A Network Cable Cat6 (23AWG) Video Support 480i / 60Hz 480p / 60Hz 576i / 50Hz 576p / 50Hz 720p / 50/60Hz 1080i / 50/60Hz 1080p / 50/60Hz HDCP Version 1.3 Transmission Length 164ft (50m) IR Remote Control Supports 20-60kHz Power Consumption TX: <2W; RX: <2W Operating Temperature 32~104°F (0~40°C) Storage Temperature -4~140°F (-20~60°C) Humidity 20-90% (non-condensing) Product Dimensions (L x W x H) 71.6 x 66.6 x 24.