Spec Sheet

Setting up the HDMI extender is as easy as plugging in the HDMI source on the
transmitter end and then plugging in the HDMI display on the receiver end. Plug
in the included IR cables on both ends to allow the IR signal to be sent remotely,
select the length of Cat6 or higher Ethernet 23AWG cable (up to 164 feet) to plug
into the Ethernet port on both ends of the transmitter / receiver, and then plug in
the included 5V 1A power adapters on both ends for operation.
Plug and Play Operation
HDMI IN CAT6 LINKDC 5V IR OUT RESET
Left Side Right Side
Transmitter (Source) Receiver (Display)
CAT6 LINKRESET
Right Side
HDMI OUT
DC 5V
IR IN
Left Side
Monitor / Television
Quick Installation
PI Manufacturing, www.pimfg.com