Instructions / Assembly

4LT PENDANT LIGHT

ASSEMBLY/INSTALLATION INSTRUCTIONS

branch circuit conductor.

shock.

All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)

standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a

referencing the illustrations on the installation instructions.

Phillips screwdriver.

Install BULB(not included). See relamping label at socket area or packaging for maximum allowed wattage.

CAUTION

GENERAL

TOOLS REQUIRED

ASSEMBLY AND INSTALLATION

(CONT.)

Turn off the power at fuse or circuit breaker.

Turn on the power at fuse or circuit breaker.

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,

CONSULT A LICENSED ELECTRICIAN.

1. Gently take all parts out of the package, lay them on a smooth surface, unscrew the BALL NUTS and the

FIXTURE SCREWS. Attach the CROSS BAR to the JUNCTION BOX using JUNCTION BOX SCREWS.

2. Install STEM connecting the upper and lower ends of the lamp body.Install STEMS based on the desired

5. Attach the CEILING PLATE to the JUNCTION BOX and fix it by turning the BALL NUTS clockwise.

length of the item on the FIXTURE, adding CEILING PLATE one finished.

Please read carefully and save these instructions, as you may need them at a later date.

3. Pull out the SUPPLY WIRES and SUPPLY GROUND WIRE from the JUNCTION BOX. Make wire

connections using the WIRE CONNECTORS:

---Attach the FIXTURE GROUND WIRE to the CROSS BAR with the GREEN GROUND SCREW.

Then connect it to the SUPPLY GROUND WIRE with a WIRE CONNECTOR.

Carefully put the wires back into the JUNCTION BOX.

4. Attach the LANYARDS on to the MOUNTING BRACKET.