Instructions / Assembly

ManualsBrandsPia Ricco ManualsLighting8.7 in. 1-Light Vintage Black Battery Operated Wall Sconce（Set of Two)

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

EXPLODED PARTS

Fixture Shade Bulb Remote Control Mounting Unit Ball Nuts Mounting Screws Wire Nuts

Adjusting Length of cord (if needed),

keep at least 6" of wire after adjustment.

Wire

strippers

Ladder

Safety

glasses

Electrical

tape

Phillips

screwdriver

Flat blade

screwdriver

Pliers

CAUTION

◆ Inspect the wire insulation for any cuts,

abrasions, or exposed copper that may have

resulted during shipping. If there is a defect

in the wire, do not attempt installation.

◆ Before starting installation of this ﬁxture or

removal of a previous ﬁxture, disconnect the

power by turning oﬀ the circuit breaker or by

removing the fuse at the fuse box.

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED

HARDWARE INCLUDED

Bulb

Shade

Socket ring

Fixture

Ball Nuts

Mounting Screws

Junction Box

(not included)

Mounting Unit

At least 6"

DECREASE

INCREASE

MOUNTING OPTION 1 for using attached bulb that comes with the product.

MOUNTING OPTION 2 for using normal medium base bulb.

Summary of content (4 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS ◆ Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation. CAUTION ◆ Before starting installation of this ﬁxture or removal of a previous ﬁxture, disconnect the power by turning oﬀ the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
MOUNTING OPTION 1 (For using attached bulb that comes with the product) STEP 1a STEP 4a Remove the socket ring from the fixture. Attach the shade onto fixture using socket ring. Unscrew the ball nuts from the mounting unit. Use the mounting screws to attach the mounting unit to the junction box (not included). STEP 2a All the wires should wrap with electrical tape (not included). STEP 5a Install LED bulb or RGB bulb.
PAGE 3
LED BULB / RGB BULB (Fig. 1) A. B. C. AA AA 1.5V 1.5 V Turn counterclockwise to open the back cover. AA 1.5V AA V 1.5 AA 1.5V AA 1.5V Close the back cover, then turn clockwise to lock Install 3 AA batteries (not included). REMOTE CONTROL (Fig.
PAGE 4
MOUNTING OPTION 2 (For using normal medium base bulb) STEP 1b STEP 4b Remove the socket ring from the fixture. Attach the shade onto fixture using socket ring. Unscrew the ball nuts from the mounting unit. Use the mounting screws to attach the mounting unit to the junction box (not included). STEP 2b Make the electrical connection from the junction box (not included) to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw.