Instructions / Assembly

Wire
strippers
Ladder
Safety
glasses
Electrical
tape
Phillips
screwdriver
PliersFlat blade
screwdriver
CAUTION
◆ Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect
in the wire, do not attempt installation.
◆ Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
Bulbs
(not included)
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
EXPLODED PARTS
INSTALLATION (PENDANT LIGHT)
STEP 1
1.Unscrew the ball nuts from
the mounting unit.
2.Use the mounting screws
to attach the mounting unit
to the junction box(not included).
STEP 2
Install swivel on of the ceiling
plate and secure with washer A,
washer B and decorative nut B.
STEP 3
Based on the desired length of
the stems (A~D), thread the
fixture wire and fixture ground
wire through the stems and the
ceiling plate, then screw them
into the fixture.
HARDWARE INCLUDED
Bulbs
(not included)
Fixture
Fixture
Stem D
Stem C
Stem B
Stem A
Stem E
Cover
Cover
Glass Shade
PENDANT LIGHT CEILING LIGHT
Fixture Cover
Washer A
Washer A
Washer B
Washer B
Washer A
Washer B
Decorative
Nut A
Decorative
Nut A
Decorative
Nut B
Decorative Nut B
Decorative Nut B
Stem EStems(A~D) Ceiling Plate
Ceiling Plate
Glass Shade Swivels
Swivels
Ball Nuts
Ball Nuts
Mounting Unit
Mounting Unit
Mounting Unit
Mounting
Screws
Mounting Screws
Mounting Screws
Wire Nuts
Wire Nuts
Wire Nuts
Decorative
Nut A
Glass Shade
Ceiling Plate
Ball Nuts