Installation Manual

ManualsBrandsPiaa ManualsAutomotivePIAA 15211 H11 Xtreme White Plus High Performance Halogen Bulb, (Pack of 2)

Thank you very much for purchasing PIAA product.

Please read these instructions before installation

and use of this product.

• Installation of this bulb is simple, just reverse the steps you took to

remove your old bulbs.

• Before installation make sure that your lamps and wiring harness are

compatible with this bulb.

Things to check prior to installation:

1. Lamp must take the same style bulb as the one you are

attempting to install.

2. Lamp must be able to dissipate the heat created by this

upgrade.

* Higher wattage bulbs will generate more heat.

3. The bulb seat must be clean.

4. The connector that plugs into the bulb must be clean.

5. The harness cannot be damaged.

6. If you are installing a higher wattage bulb you must check to

see if the relay harness is capable of the extra amperage.

If any of the above listed are not checked and fixed this bulb will not

perform and if they are not fixable you cannot use this bulb

Bulb Instruction Manual

Summary of content (4 pages)

PAGE 1
Bulb Instruction Manual Thank you very much for purchasing PIAA product. Please read these instructions before installation and use of this product. • Installation of this bulb is simple, just reverse the steps you took to remove your old bulbs. • Before installation make sure that your lamps and wiring harness are compatible with this bulb. Things to check prior to installation: 1. Lamp must take the same style bulb as the one you are attempting to install. 2.
PAGE 2
INSTALLATION For detailed instructions on your vehicle consult your vehicle owner's manual. 1. Turn off vehicle, set parking brake, and disconnect negative battery cable. 2. Locate the bulb(s) you wish to replace. 3. Remove the plug from the harness that connects to the back of the bulb. 4. Remove the clip(s) and or spring that holds the bulb in the lamp. 5. Carefully remove bulb, do not touch or bump it on anything if you plan on reusing it later.
PAGE 3
TESTING 1. Start vehicle and turn on lights and test them. 2. The first test is to turn on the low beam and go to the front of the lamp and check that it is the low beam filament that is on and that the high beam is turned off. 3. The second test is to turn on the high beam and go to the front of the lamp and check that it is the high beam filament that is on and that the low beam is turned off. Notice: Some bulbs only have one fillament. in this situation there is only on and off 4.
PAGE 4
• NEVER touch the glass tube with anything including your hands as residue and/or oils will greatly reduce the life span of the bulb. Oils may actually cause the bulb to burst when turned on. If you do get a substance on the bulb you must clean it thoroughly with a cleaner that leaves no oil or residue such as an alcohol cleaner, before turning the bulb on. • NEVER turn on the bulb when it is not fastened into the lamp.