Manual

-2-
PLI-1165
● This lamp is provided with a bracket for use as a hanging type lamp. When using it in an upright position, make sure the
logo is correctly displayed and the water outlet holes are on the bottom of the unit. Install by rearranging the bracket.
● All work procedures should be carried out in a location with adequate space. Place the shift lever in neutral or in the parking
position. Turn off the engine and set the side brake.
● Do not begin work if engine parts such as radiator, oil-cooler or turbo part are still hot.
● Be extremely careful when handling the lamp and relay harness. If dropped or excessive shock is applied to the lens, bulb or
relay harness, it may cause irreversible damage.
● Do not add additional holes to the main body of the lamp. Also, do not apply adhesives or stickers to the lamp parts.
● Make sure all bolts are tightly secure. If there are any loose bolts tighten them accordingly.
● After installing the lamp, make sure the headlamps, wipers and horn are working normally.
Please read the installation procedures thoroughly beforehand.
● When doing wiring work, strictly follow the cautionary points mentioned below. Incorrect or faulty wiring may cause the lamp
to operate improperly. In some cases, it may cause the vehicle to catch fire.
Caution Regarding Wiring / Please read thoroughly
● Before you begin always remove the (-) terminal.
● When removing the battery terminals, always turn the key to OFF and remove it. Turn all other
electrical units off such as the light switch.
● Verify the (+) terminal (white) and earth (black) before connecting.
● Install the harness in a position where it will not make contact with high temperature surfaces such as the engine,
radiator or engine compartment.
● Arrange the harness so that it does not make contact with moving parts.
● Do not place the harness on high-voltage wires such as brake or air-conditioning wires.
● If the harness makes contact with a part of the engine, apply a length of ordinary cushioned tape around the harness.
● Do not tie the harness in a bundle by bending into too many folds. The relay harness may
overheated.
● When connecting the terminal, make sure to install it correctly and
secure it into position.
● Make sure the harness does not sag. Use a harness band
of vinyl tape to secure it in place inside the engine compartment.
● When removing the terminal, hold the main body of the terminal
and pull it out. If excess force is used to pull the cord, it may damage
the connection, which could cause it to overheat.
● Before connecting it to the battery, verify the wiring arrangement.
● After all wiring is complete, confirm that it works properly.
● Do not draw power from the battery on a regular basis as it may cause a battery drain.
×
×