User manual

3) Slide the cowl back over the and secure it in place using three

wood screws. See picture below.

edges of the firewall. Using a 3mm drill bit, enlarge the three holes in the

cowling.

motor

Drill 2.5mm pilot holes through both side of the cowl and the side three

. Item code: BH163 DORNIER DO335

1) Slide the fiberglass cowl over the and line up the back edge of the cowl with the marks you made on the

fuselage.

2) While keeping the back edge of the cowl flush with the marks, align the front of the cowl with the crankshaft of the

. The front of the cowl should be positioned so the crankshaft is in nearly the middle of the cowl opening. Hold the

cowl firmly in place using pieces of masking tape.

motor

3x15mm

Secure

Drill 2.5mm and

3x12mm.Secure