The World Models Basic fabrication of fuselage is complete. Check any lug: sa. loins and distortion of the frame wail, Frappe to ag: ply. glue the next step. Apply CA gus to all surfaces in contact Apply trim both sides in and out:and let glue Spitfire joints. Usd extension Tiber microlight side spaniel Roles 10 get alas to inside: of-fuselage. Avoid area with tapes at this stage, when leis cured at other areas, remove tape and apply glue o-area under the tapes.
The World Models MAIN WING ASSEMBLY Lay oUt pars for the Wings, Lift up wing rate carefully and fate in Wi2: then in WOR. W12R, WIR. Apply:CA 16 gus W15R in place, use straight angle 10 make sure angle is right: Apply GA toluene Wiry and WOR in place; use straight fs fo ‘ensure bath are straight whee gluing. Wis cred apply Gate cal Headhunting stale, inside and WHO and WEA in place.
The World Models Flip over digit wing with wing bottom wp. Latch in Wig WSR, with bird n0t facing inside wing: Apply GA fo glue Flip over wing: with ballroom up: dido in Wa TA, W32, Wis, iii place; Gide in WE Whether fip over wing fo bat: N20, Was. Align the role an Wig-with the blind hut heel fans down, lug idx F18 dnd add CA to contactable sulfa: tor wing: strut installation.
The World Models VERTICAL STABILIZER AND RUDDER ASSEMBLY Lay aut parts tor th vertical fin and flare BHU mse findings to WIA herniation to WISH. Appalachia Was, W37, Was and Wid ahd Goethe: i piss, Take out aileron and use: sand paper fo remove rough edges. = Glue VS.ta V2: C..Glue V4 1 V2.0 Insert hinges to. V2 and outface V1{, heck smelt operation of hires. E.
WING STRUT ASSEMBLY Apply CA le sandwich the: aluminum wing. struts with wood sleeve; Expo minim of the aluminum wing struts outside wold sleeve. Remove rough edges with'sand paper. HORIZONTAL STABILIZER AND ELEVATOR ASSEMBLY Layout pans for: horizontal stabilizer aid Translator. The World Models BE A Align iSa te middies ot ST and dopey CA ty glue in place: B: Glue: 53 toot, fush:atthe tear sedge. C/D: insert hinges to 52 and attach to &1, GIUSEPPE In topper ube spacer. Fi: Lat oh 85 to Si. apply.
