Datasheet


This set of breakout leads is ideal for
1YPXM'34TEGOW7MQTP]ƼXSRIPIEH
between each coil pack and plug,
place an MI074 secondary ignition
pickup on each lead, and your scope
will show accurate ignition waveforms
with correct kV measurements.
Coil-On-Plug and Signal probe
Order Code: PP357
HT Extension lead
(set of 4 leads)
Order Code: PP400
Secondary ignition pickup
(capacitive with BNC)
Order Code: MI074
Add to Starter kits to pick up
secondary ignition waveforms from
most coil-on-plug or coil-per-cylinder
systems.
The MI074 is a capacitive pickup that
connects around the insulation of an
ignition circuit component (such as
a plug wire), avoiding the need for
direct connection. Use our MI074 in
GSRNYRGXMSR[MXLSYV,8I\XIRWMSR
leads to read Multi COP signals.
Back-pinning probes
Order Code: TA008
Fuse extension leads kit
Order Code: PP967
1400 V Differential probe
Order Code: TA057
The back-pinning probes slip down
the side of the insulation on the back
of multi-plug terminals, allowing you
to pick up signals without stripping
wires or disconnecting plugs. With
spare pins and screws included, these
are a must have for any diagnostic
technician.
(S]SYƼRHMXLEVHXSFVIEOMRXS
particular vehicle circuits? With
4MGSƅWJYWII\XIRWMSRPIEHW]SYGER
IEWMP]I\XIRHXLIJYWIGSRRIGXMSR
to allow space for a current clamp
and measure the current draw for
the circuit. Set includes ATC, mini-
%8'.'%7)ERH1E\MWX]PIJYWI
I\XIRWMSRW
Add our 1400 V differential probe to
any kit and it allows the measurement
of much higher voltages, which is ideal
for hybrid and electric vehicles.
This probe has a bandwidth of 25
MHz, with differential voltage ranges
SJɸ:ERHMW'%8---VEXIH