Brochure

The secondary ignition pickup enables the
PicoScope to measure high-tension (HT)
voltages in secondary ignition circuits. It clips
onto the HT lead with no need to disconnect the lead.
The lead includes a ground clip that you must always connect to
battery negative (earth) to prevent stray voltages from damaging
the PicoScope.
The Coil-on-Plug (COP) probe can pick up secondary
ignition waveforms from most coil-on-plug or
coil-per-cylinder systems where there are no exposed
HT leads. The signal is displayed in PicoScope as kilovolts
(kVs).
These extension leads give access to the HT (secondary)
ignition circuit in coil-on-plug engines. Fit the COP Extension
Lead between the coil and the plug, then place a Secondary
Ignition Pickup on the lead to pick up the HT pattern on
your PicoScope. Includes an earth (ground) wire to ensure
safety.
The Mixmaster can display up to 12 secondary ignition signals in a parade display on
your PicoScope. It is supplied with 4 secondary ignition pickup leads. Additional leads
are available separately.
Mixmaster PP361 £225 $371.25 ¤272.25
Extra pack of 4 short secondary ignition pickups
PP339 £60 $99 ¤72.60
SECONDARY IGNITION PICKUP
COIL-ON-PLUG (COP) PROBE
Coil-on-plug probe only PP338
£95 $156.75 ¤114.95
BNC to BNC cable with ground clip TA033
£15 $24.75 ¤18.15
Coil-on-plug probe kit (probe and cable) PP357 £105 $173.25 ¤127.05
COIL-ON-PLUG (COP) PROBE EXTENSION LEADS
COP extension leads each TA037 £25 $41.23 ¤30.24
COP extension leads x4 & Earth wire PP400 £95 $156.73 ¤114.94
MIXMASTER
Secondary ignition pickup MI074 £35 $57.75 ¤42.35