User manual

USB DrDAQ User's Guide 3
Copyright © 2011 Pico Technology Ltd. All rights reserved. usbdrdaq.en
2.3
Safety warnings
Warning triangle
This symbol indicates that a safety hazard exists on the indicated
connections if correct precautions are not taken. Read all safety
documentation associated with the product before using it.
Safety warnings
USB DrDAQ ground is connected directly to the ground of your computer. As with
most oscilloscopes and data loggers, this is done in order to minimise interference.
You should take care not to connect the ground (screw terminal, outer shell of BNC or
exposed metalwork) of USB DrDAQ to anything which may be at some voltage other
than ground, as doing so may cause damage to the unit. If in doubt, use a meter to
check that there is no significant AC or DC voltage.
For computers that do not have an earth connection (for example, laptops), it must be
assumed that USB DrDAQ is not protected by an earth (in the same way a battery
multimeter is not protected by an earth).
The scope channel on the USB DrDAQ has a maximum input voltage range of ±10 V.
The maximum input voltage for all other inputs is 0 to 5 V. Any voltage in excess
of ±30 V may cause permanent damage to the unit.
Your own sensors should draw no more than 100mA from the 5V, the USB DrDAQ is
not limited or protected so overcurrents or shorts could cause damage to the PC USB
port.
The unit has no user serviceable parts: repair or calibration of the unit requires
specialised test equipment and must be performed by Pico Technology Limited or
their authorised distributors.
2.4
Legal information
The material contained in this release is licensed, not sold. Pico Technology Limited
grants a licence to the person who installs this software, subject to the conditions
listed below.
Access
The licensee agrees to allow access to this software only to persons who have been
informed of these conditions and agree to abide by them.
Usage
The software in this release is for use only with Pico products or with data collected
using Pico products.
Copyright
Pico Technology Limited claims the copyright of, and retains the rights to, all material
(software, documents etc.) contained in this release. You may copy and distribute the
entire release in its original state, but must not copy individual items within the
release other than for backup purposes.
Liability
Pico Technology and its agents shall not be liable for any loss, damage or injury,
howsoever caused, related to the use of Pico Technology equipment or software,
unless excluded by statute.