User manual

Menus80

Start from...

Use this button to enter a condition that PicoScope will wait for

before collecting data. When PicoScope detects a packet that

matches this condition, it will collect all subsequent data (subject to

filtering, if used - see above) and display it in the table.

Filter

Click to show the filter bar, which allows you to enter arbitrary data

above each column in the table. The table will display only those

packets that match the data you have entered. For example,

entering "6C7" in the filter box at the top of the ID column will

cause only frames with an ID of 6C7 to be displayed.

Statistics

Toggle the statistics columns that list measurements such as packet

start and end times, and signal voltages.

Search for any data value in a specified column of the table.

Refresh

Instructs PicoScope to decode the raw data again. This is necessary

if you have changed the Start from... condition, for example.

Clear

Clear all data and settings in the table. New data will appear the

next time that the scope captures a waveform.