User's Manual

Battery / switching on / SEND mode
IMPORTANT: Only use battery type LR03/AAA and always replace all 3
batteries with new ones of the same type. Never use rechargeable
batteries and always change all batteries at the same time!
Depress the main switch lock and push the main switch to the “SEND“ position.
In this mode, the PIEPS DSP will carry out a self-test lasting approx. 5 seconds.
You will then see the send symbol and the remaining % battery voltage in the
display. The LED will also flash synchronously with the transmitter bit timing.
In the event of a device error, a 5-second warning tone sounds. This means the
device is not fit for operation. In this case, contact our customer service
department.
When in the open, make sure the “SEND” mode is selected throughout. The
PIEPS DSP will then transmit continuously any signal it picks up from other
detectors.
IMPORTANT: When switched on, a complex self-testing is done by the
beacon itself, nevertheless a LVS-check stronlgy recommended in
preperation to each tour !
The battery compartment is located at the rear of the housing. The safety screw
connection can be easily opened and closed using a coin.