User Manual

14
Wet/Dry Routing
The dual outputs of the Infinity 2 can be routed for stereo output with clean pass-through and
loop audio mixed together, or they can be configured for discrete Wet/Dry operation - where
the loop audio is summed to Out 2, and clean pass-through audio is summed to Out 1.
To turn on the WET/DRY routing mode, press and hold the MODE switch until the LOOP
1 and LOOP 2 LEDs turn green during power up. Once this operation has been performed, a
sticky flag is set to allow the Infinity 2 to remain in WET/DRY routing mode, even when the
power is turned off.
The STOP LED will illuminate during boot up to indicate WET/DRY routing mode has been
turned on
To turn off the WET/DRY routing mode, press and hold the MODE switch during power up.