User's Manual

Pilz GmbH & Co. KG, Sichere Automation, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: [phone], Telefax: [phone], E-Mail: [e-mail]
5-5
5.3 Inserting and removing an electronic module
5 Installation
5.3Inserting and removing an electronic module5300Inserting and removing an electronic module5-
Please note:
` Only insert on to base modules that are already installed.
` Preferably these base modules should be ready wired.
` Electronic modules with outputs may only be inserted and removed
when the load is switched off. Unforeseeable error reactions may be
triggered if modules are inserted and removed under load.
` When an electronic module is plugged into a base module for the first
time, one part of the coding element remains on the electronic module,
while its counterpart is fixed on to the base module. This is how the
base module is coded.
` The mechanics of the electronic modules are designed for 50 plug in/
out cycles.
5.3.1 Inserting an electronic module
Inserting an electronic module5-
Procedure:
` The electronic module must audibly lock into position [1].
` Mark the electronic module using the labelling strips [2].
Schematic representation:
[2]
[1]
[1]