Operating Manual

PIT gb RLLE y ETH
Operating Manual PIT gb RLLE y ETH
1005249-EN-01
| 6
INFORMATION
This gives advice on applications and provides information on special fea-
tures.
Overview
Unit features
} Slimline design
} Labelling option for individual marking of the control elements
} Control elements finally wired and installed
} Housing with E-Stop pushbutton, 2 pushbuttons and PITreader
} PITreader as electronic key switch for operation and authentication with a transponder
key PITreader key (see Order reference: Transponder key [ 23])
} Can be installed in different directions (see Assembly positions [ 13])
} Coloured caps for marking the function of the control elements (see Order reference:
Accessories [ 23])
} PIT gb RLLE y ETH has a 12-pin M12 male connector and a 4-pin M12 female connector
PIT gb RLLE y ETH is available in two types. Unless stated otherwise, diagrams show the
type with plug-in connectors at the opposite end to the E-STOP.
– PIT gb RLLE y up ETH with male connectors at the E-STOP end
– PIT gb RLLE y down ETH with male connectors at the opposite end to the E-STOP
Scope of supply
} PIT gb RLLE y up/down ETH
} 2 washers M5
} Coloured caps (set), sorted by colour
Safety
Intended use
The unit PIT gb RLLE y ETH is intended for use in safety circuits in accordance with IEC/
EN60947-5-5, ENISO13850. Before using the device, a safety assessment of the overall
system must be performed in accordance with the Machinery Directive.
The PIT gb RLLE y ETH is a system for authentication and authorisation on control sys-
tems. Authentication is via transponder key.
The PIT gb RLLE y ETH must be used in combination with a suitable evaluation device
(see Connection to evaluation device [ 15]).
The following is deemed improper use in particular:
} Any component, technical or electrical modification to the product
} Use of the product outside the areas described in this manual