User Manual Part 1

PSENcs5.1p
OperatingManualPSENcs5.1p
1003418EN01
21
Procedure:
1. Drillholes(forM4screws)inthemountingsurfacetosecuretheactuatorandsensor
(seeDimensionsinmm[ 23]).
2. Useascrewtofixthesensortothemountingsurface.
Makesurethatthesensormarkingthatisbeusedforoperationcanbeoperatedusing
theactuatorfromtherightside.
3. Donotfullytightenthesecondscrewonthesafetyswitch.
4. Useascrewtofixtheactuatortothemountingsurface.
Makesurethattheactuatorwiththemarking(triangle)pointstowardsthemarkingon
thesensor.
5. Donotfullytightenthesecondscrewontheactuator.
6. Alignthesafetyswitchandtightenthescrews.
7. Aligntheactuatorandtightenthescrews.
Forsimplerinstallation,themountingbracketswithordernumber532110canbeused.
Adjustment
} Thestatedoperatingdistances(seeTechnicaldetails[ 24])onlyapplywhenthe
safetyswitchandactuatorareinstalledfacingeachotherinparallel.Operatingdis
tancesmaydeviateifotherarrangementsareused.
} Notethemaximumpermittedlateralandverticaloffset(seeOperating
distances[ 10]andLateralandverticaloffset[ 13]).
Operation
Checkthefunctionofthesafetyswitchbeforecommissioning.
Statusindicators:
Legend:
LEDoff
LEDon
LEDflashes(500mson,500msoff)
LEDflashesquickly(50mson,950msoff)