User's Manual

PINEAPPLE TECHNOLOGY, INC V.6. ADAPTIVE PRE-CORRECTOR WEB SERVICE OPERATION

DXDPRO-10U MODULATOR MANUAL

THE INFORMATION PROVIDED HEREIN IS PINEAPPLE TECHNOLOGY INCORPORATED PROPRIETARY INFORMATION AND

CANNOT BE COPIED OR DISTRIBUTED WITHOUT PRIOR AUTHORIZATION

V.6 DXDPRO-10U ADAPTIVE PRE-CORRECTOR WEB SERVICE OPERATION (Continued)

C. OPERATION OF ADAPTIVE PRE-CORRECTOR

2. Preparation of Web Service Interface

To enable web service control of the non-linear and linear adaptive pre-corrector, proceed as follows:

a) Drag the linear pre-corrector block to the configuration panel

b) Drag the non linear pre-corrector block to the configuration panel

c) Drag the adaptive pre-corrector block to the configuration panel (this panel provides status info

only and it is therefore as such not strictly required for operation of the adaptive system)

d) Drag the three control blocks into the configuration panel one-by-one:

Depending on the current operational mode for the pre-corrector system the linear and non-linear blocks

may appear in grey or in green. When the pre-corrector function is disabled the respective block (linear

and/or non-linear) is shown in grey. When the pre-corrector function is enabled the respective block

(linear and/or non-linear) is shown in green color. When the active pre-corrector mode is ‗adaptive‘ a

green arrow will connect the adaptive function block and the respective pre-corrector block. When the

adaptive pre-corrector mode is ‗static‘ (manual correction mode) the connection between the adaptive

function block and the respective pre-corrector block is grayed out.