User's Manual

PINEAPPLE TECHNOLOGY, INC. V.5 - ETHERNET WEB PAGE CONTROL AND MONITORING
DXDPRO-10VH MODULATOR MANUAL
THE INFORMATION PROVIDED HEREIN IS PINEAPPLE TECHNOLOGY INCORPORATED PROPRIETARY INFORMATION AND
CANNOT BE COPIED OR DISTRIBUTED WITHOUT PRIOR AUTHORIZATION
40
V.5 . ETHERNET WEB PAGE CONTROL AND MONITORING (Continued)
D. WEB SERVICE OPERATION
3. Web Service - Operation Principle
Setting Of A Parameter Value
To change the setting of a specific user parameter, proceed as follows:
1. If not already available for modification, move the functional block in which the parameter resides to the
control panel in the lower section of the screen as described above.
2. Place the cursor over the location in the control panel where the parameter of interest resides and click the
left mouse button to set the point in focus. Depending on the type of input set the new value as required.
The input can be ‗alpha-numeric for input by keyboard‘ or based on a drop-down list holding the valid
choices or based on a tick-box or radio-button system. Notice that some fields are status displays only
(read only) and that, consequently, it isn‘t possible to access these fields for parameter change.
3. When the new value has been specified the border of the field in question will be presented in a light blue
color to indicate that a new value has been specified but not yet implemented/confirmed.
4. To implement/confirm the new value move the cursor to the [Apply] button and click the left mouse button
to confirm the entry.
5. When the new value has implemented/confirmed the light blue border around the parameter input field will
return to the normal black color.
Parameter control of
the ’drop-down’ list
type. The control will
provide the list of valid
choices for selection
when left-clicked with
the mouse.
Parameter control of
the ’radio-button’ type.
Select a new value by
left-clicking the value in
the control.
Parameter control of
the ’tick-box’ type. Left
click the control to
toggle the value
between the two
possible states
Parameter control for
numeric input. Specify
the value using the
keyboard after selecting
the control by left-
clicking the mouse.
Note the grey border
which indicates that this
box accepts user input.
Parameter box of the
read-only type (status
only). This box differs
from the ‘input‘ type of
box by the absence of
the grey border that
characterizes the boxes
for alpha-numeric input.
Apply button for
implementing/confirming the
new parameter value
Clear button for canceling a
modified but not yet
implemented/confirmed
parameter value