User's Manual

PINEAPPLE TECHNOLOGY, INC V.6 - ADAPTIVE PRE-CORRECTOR WEB SERVICE OPERATION

DXDPRO-10VH MODULATOR MANUAL

THE INFORMATION PROVIDED HEREIN IS PINEAPPLE TECHNOLOGY INCORPORATED PROPRIETARY INFORMATION AND

CANNOT BE COPIED OR DISTRIBUTED WITHOUT PRIOR AUTHORIZATION

V.6. ADAPTIVE PRE-CORRECTOR WEB SERVICE OPERATION

A. INTRODUCTION

This section describes the web browser based operation of the adaptive pre-corrector for the PT2000

Terrestrial Gateway unit. For an introduction to IP address configuration, log-in procedure and general

operation principle for the web service

control interface for the DXDPRO family please refer to the separate

publication DXDPRO Modulator and Repeater Products Web Service Interface Instruction Manual available

from Pineapple Technology, Inc.

The web service control interface allows monitoring of status as well as configuration of the operational

parameters of the adaptive pre-corrector device subject to the log-in status for the user (observer, operator

or administrator). The user interface (web browser display) applies a user friendly concept where the general

navigation between individual sub menus is based on a block oriented representation of the controlled

device. The specific control for a certain function is therefore easily accessed by ‗dragging‘ the functional

block of interest into the configuration section of the display.

The web service interface is equally useful for controlling any of the PT2000 Terrestrial Gateway products in

a configuration with a direct connection (Ethernet patch cable) between the PT2000 Terrestrial Gateway unit

and the PC as well as in the typical operational environment where multiple products are accessible from the

PC across a shared network.

SECTION STRUCTURE AND SCOPE

This section is divided into three main chapters:

a. Electrical interface for the adaptive pre-corrector;

b. Operation principle for adaptive pre-corrector ; and,

c. Application of the adaptive pre-corrector in combination with Echo Canceller option.

B. ELECTRICAL INTERFACE

1. General information

The adaptive pre-corrector‘s electrical interface consists of two SMA type coaxial connectors:

 Sense input 1: Non-linear sense port

 Sense input 2: Linear sense port