User's Manual

PINEAPPLE TECHNOLOGY, INC V.6 - ADAPTIVE PRE-CORRECTOR WEB SERVICE OPERATION

DXDPRO-10VH MODULATOR MANUAL

THE INFORMATION PROVIDED HEREIN IS PINEAPPLE TECHNOLOGY INCORPORATED PROPRIETARY INFORMATION AND

CANNOT BE COPIED OR DISTRIBUTED WITHOUT PRIOR AUTHORIZATION

V.6 ADAPTIVE PRE-CORRECTOR WEB SERVICE OPERATION (Continued)

C. OPERATION OF ADAPTIVE PRE-CORRECTOR

2. Preparation of Web Service Interface

To enable web service control of the non-linear and linear adaptive pre-corrector, proceed as follows:

a) Drag the linear pre-corrector block to the configuration panel;

b) Drag the non linear pre-corrector block to the configuration panel;

c) Drag the adaptive pre-corrector block to the configuration panel (this panel provides status info

only and it is therefore as such not strictly required for operation of the adaptive system); and,

d) Drag the three control blocks into the configuration panel one-by-one.

Depending on the current operational mode for the pre-corrector system, the linear and non-linear blocks

may appear in grey or in green. When the pre-corrector function is disabled the respective block (linear

and/or non-linear) is shown in grey. When the pre-corrector function is enabled the respective block

(linear and/or non-linear) is shown in green color. When the active pre-corrector mode is ‗adaptive‘ a

green arrow will connect the adaptive function block and the respective pre-corrector block. When the

adaptive pre-corrector mode is ‗static‘ (manual correction mode) the connection between the adaptive

function block and the respective pre-corrector block is grayed out.