Installation Guide

LTL Home Products, Inc. • 125 Route 61 • Schuylkill Haven, PA 17972
800-360-1585
www.ltlhomeproducts.com
[e-mail]
1 - Place shutter next to window at desired location.
2 - Clearly mark screw hole location with a pencil. Non-corrosive screws should be
marked 4’’ to 6’’ from the top and bottom of shutter, and within 1’’ above where the
siding makes contact with the shutter. This allows for maximum screw penetration.
3 - The remaining screw holes should be located an equal distance from each other in the same fashion as
above.
On the 81’’ shutter, two additional screw holes should be marked at shutter’s midpoint for added stability.
Make sure these holes are also within 1’’ above where the siding makes contact with the shutter.
1 - Drill holes centered on shutter side rails at marked locations. Drilling should be done on bench or ground.
DO NOT drill holes into house siding.
1 - Place shutter next to window at desired location.
2 - Place non-corrosive screws through previously drilled shutter holes and tap to start them. Tighten screws
only until the head touches the surface of the shutter. DO NOT force down tightly or puncture through siding.
Spacers should be used to keep shutter from direct contact with the mounting surface. This helps to
retard moisture accumulation between the shutter and mounting surface.
- locate screw holes so they enter
mortar joints. Drill holes to accept a suitable masonry anchor and attach shutter.
LTL Home Products, Inc. - 125 Route 61 - Schuylkill Haven - PA - 1797