Operation Manual

Operation manual : For the first time to use Need to frequency bind Take out the.remote control, install
the battery.Longpressonthefrequencykey2-4seconds, Lowspeed LED light swill flash.Turnon the power of the
car, Lowspeed LED light swill from flash tolong lighting, then frequency bind succeed.If the frequency
bind failed (Low speed LED lights flash) , removethe battery and repeat steps l ~3.remote control
without operation after 10 seconds, indicationlightwilloffinto power savingmode.
Button Description: forward backward turn left turn right.
S: Speed P: emergency brake, press it and the runningfunctionwill fail, press again, it release.
Operation frequency:2405-2479MHz
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐‐Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.