Installation Instructions

Instruction for 2.4G Remote Control of Electric Ride-on Car
◼ Features
-Supply Voltage：2 X 1.5V
-Frequency：2.4GHz
◼ Button Description
-Forward: Direct the ride-on car to move forward
-Backward: Direct the ride-on car to move backward
-Paring: Pair the ride-on car with a remote controller
-Left: Direct the ride-on car to turn left
-Right: Direct the ride-on car to turn right
-Speed: Adjust the speed of the ride-on car’s movement as low, moderate or high
-Brake: Immediately stop the ride-on car and lock the car until released
◼ Pairing Instruction
1. Turn on the power of the ride-on car, press and hold the pairing button until the speed
indicator light switches on without flashing
2. Release the pairing button, and the speed indicator light will switch off
3. If the speed indicator light switches on again, then the pairing is successful; if not, please
repeat steps 1 and 2
4. One successful pairing is all, and no more pairings are needed in later use
◼ Battery installation
Open the back cover of the remote control and insert two triple A batteries (AAA 1.5V).
Please pay attention to the polarity. Close the back cover and tighten the screws when the
LED light is on, indicating battery installed properly.
Battery needs to be replaced when the LED light dims or blinks.