- Pinnacle Pellet/Corn Furnace Installation/Operator's Manual
Table Of Contents
- Installation/Operator’s Manual
- FURNACE SPECIFICATIONS
- CONTROL AND COMPONENT FUNCTIONS
- CLEARANCE TO COMBUSTIBLES
- CHIMNEY AND VENTING
- VERTICAL CHIMNEY’S
- DUCTING
- ELECTRICAL REQUIREMENTS
- TURNING OFF THE UNIT
- MAINTENANCE
- BURNING CORN IN THE GBU070
- START UP INSTRUCTIONS – PELLET
- START UP INSTRUCTIONS – CORN
- PRIMARY CONTROL OII 350S
- SEQUENCE OF OPERATION
- TROUBLE SHOOTING GUIDE
19. Doors and heat exchanger surfaces of the furnace are hot during operation.
DO NOT
touch with bare hands, or allow children to play near the furnace unattended.
20. Do not allow anyone to operate the furnace that is not familiar with its operation.
21. Manually place fuel in the fire pot
ONLY when starting a fire in a cold furnace. Never
add pellets by hand to a smouldering fire or a hot fire pot.
DANGEROUS smoking
could result.
22. After lighting, make sure the main fire door and ash door are closed and sealed
tight.
23. Set combustion air damper at not less than 50%. Damper settings will vary widely
depending on draft characteristics of your chimney system. The unit should emit no
visible smoke from the exhaust, if it does, open the damper slide until smoke is
gone. Draft characteristics should be between .04 and .08 inches water.
5