Installation Guide
3
ATTENTION INSTALLER: SAVE THESE INSTRUCTIONS
GIVE THIS MANUAL TO THE BATH OWNER.
CONTAINS IMPORTANT SAFETY INSTRUCTIONS PERTAINING TO RISK OF
INJURY TO PERSONS
READ AND FOLLOW ALL INSTRUCTIONS
WARNING: Risk of accidental injury or drowning. Do not permit children to use this bath unless they are closely
supervised by a responsible adult at all times. Never leave a full bath unattended.
WARNING: PROLONGED IMMERSION IN HOT WATER MAY INDUCE HYPERTHERMIA! Water temperature should never exceed
104º F. Soaking for up to 30 minutes in water temperatures between 100º F and 104º F is considered safe for
a healthy adult. Warmer water and increased exposure times increases the risk of Hyperthermia, which can
be fatal. Water temperature should not exceed 100º F for young children when exposure times exceed 10
minutes. Hyperthermia may cause an inability to perceive heat, physical inability to exit the bath, inability to
recognize impending hazard, inability to recognize the need to exit the bath, and unconsciousness resulting
in danger of drowning. Symptoms of Hyperthermia include nausea, dizziness and fainting.
WARNING: Risk of accidental injury or drowning. Never use this bath while under the inuence of alcohol,
anticoagulant, stimulants, antihistamines, vasconstrictors, vasodilators, hypnotics, narcotics, or tranquilizers.
CAUTION: To avoid injury, exercise care when entering or exiting this bath.
CAUTION: To avoid risk of scalding skin, check water temperature before entering bath and
adjust as necessary.
IMPORTANT!: Signature Baths are intended for indoor use only with installation in accordance
with all instructions in this book.
IMPORTANT!:To reduce the risk of personal injury and discoloration of the acrylic surface,
water temperatures from the inlet should not exceed 140º F. Use supply lines suitable for
167º F, including the temperature rating of supply conductors to be used.
IMPORTANT!: Do not drop or insert any object into any opening.
IMPORTANT!: Do not use attachments or accessories not recommended by Signature
Bath.
IMPORTANT!: When required by local codes, install a RPZ (reduced pressure zone) back
ow prevention device to each faucet supply line.
IMPORTANT!: Unauthorized modication may cause unsafe operation and poor
performance.
Installation of your Signature Bath requires a working knowledge of construction, plumbing and electrical installation. The owner/
installer bears all responsibility to comply with all state and local codes when installing this product. For optimal enjoyment and
satisfaction, Signature Bath recommends installation and servicing be performed by qualied, licensed professionals in compliance
with State and Local Codes. Walls and oors should be re safe. Problems resulting from improper installation are not covered under the
warranty.
This bath does not require support in excess of other baths of the same size, weight and gallon capacity. Signature Bath has
obtained applicable code listings available on a national basis that are generally available for products of this type. It is the
responsibility of the owner/installer to determine specic local code compliance prior to installation. Signature Bath does not
warrant or represent and is not responsible for any code compliance. Product specications are subject to change from time to time
at the manufacturer’s discretion without notice.