506 Twin Oaks Drive Johnson City, TN 37601 SOAKING SERIES Installation Instructions
TABLE OF CONTENTS Important Safety Information .........................................................................................................................3 Important Installation Information .................................................................................................................4 Testing Prior to Taking Indoors .......................................................................................................................
ATTENTION INSTALLER: SAVE THESE INSTRUCTIONS GIVE THIS MANUAL TO THE BATH OWNER. CONTAINS IMPORTANT SAFETY INSTRUCTIONS PERTAINING TO RISK OF INJURY TO PERSONS READ AND FOLLOW ALL INSTRUCTIONS WARNING: Risk of accidental injury or drowning. Do not permit children to use this bath unless they are closely supervised by a responsible adult at all times. Never leave a full bath unattended. WARNING: PROLONGED IMMERSION IN HOT WATER MAY INDUCE HYPERTHERMIA! Water temperature should never exceed 104º F.
!!ATTENTION INSTALLER!! Before taking the bath indoors for installation, thoroughly inspect bath for: • Shipping Damage: Report shipping damage to the carrier immediately. DO NOT INSTALL A DAMAGED BATH. Signature Bath is not responsible for damage that occurred during transit. • Factory Defect: Manufacturing defects must be reported to Signature Bath before installation. Defects or damage claimed after installation are not covered under the warranty.
FRAMING THE BATH For proper drainage and stability, your Signature bath must be level and the full bottom of the full bath be seated firmly on the subfloor. If the sub-floor requires leveling, measurements must be adjusted to include clearance for mortar between the floor and the bottom of the bath. The rim of the bath will not support weight. Three Wall Alcove Installation: The interior of the alcove must be the same size as the exterior dimension of the bath.
floor is level, proceed with the installation. If the floor is not level, the full bottom of the bath must be seated in mortar. Following the manufacturer’s instructions, prepare and spread an even layer of mortar between the sub-floor and the full bottom of the bath. With the drain in the bath aligned with the drain in the floor, being careful not to damage the bath or the components, put the bath in place.
responsible adult at all times. Never leave a full bath unattended. WARNING: The use of alcohol, drugs or medication can greatly increase the risk of fatal hyperthermia. Never use this bath while under the influence of alcohol, anticoagulant, stimulants, antihistamines, vasconstrictors, vasodilators, hypnotics, narcotics, or tranquilizers. WARNING: Risk of fetal injury. Water temperatures exceeding 100º F can increase the potential of fetal damage during early pregnancy.
SIGNATURE BATH MANUFACTURER’S LIMITED WARRANTY for Soaking Baths Warranty Coverage Throughout this document, Signature Bath shall be referred to as the “MANUFACTURER”. The following expressed limited lifetime warranty is given to the original consumer of a Luxury or Luxury Plus Series Signature Bath purchased for personal or single family residential use. Any commercial applications are excluded from all warranties.
506 Twin Oaks Drive Johnson City, TN 37601