Walk-In Series Installation Guide (Shown here with faucets which are not included) Certified
IMPORTANT SAFETY INSTRUCTIONS PLEASE READ AND FOLLOW ALL INSTRUCTIONS PROVIDED CAREFULLY Install to allow adequate access for maintenance and the possibility of future servicing. "An equipment grounding terminal is provided in the field wiring compartment. To reduce the risk of electric shock, this terminal must be connected to the grounding means provided in the electric supply panel with a conductor equivalent in size to the circuit conductors supplying this equipment" FOR INDOOR USE ONLY.
WARNING – When using electrical products, basic precautions should always be followed, including the following: CAUTION: RISK OF ELECTRIC SHOCK, DISCONNECT ELECTRIC POWER BEFORE SERVICING 1. DANGER: RISK OF ELECTRIC SHOCK. Connect only to a circuit protected by a ground-fault circuit-interrupter.Grounding is required. The unit should be installed by a qualified service representative and grounded. 2.
WARNING: RISK OF ACCIDENTAL INJURY OR DROWNING, CHILDREN SHOULD NOT USE HYDROMASSAGE BATHTUB WITHOUT ADULT SUPERVISION. WARNING: RISK OF ACCIDENTAL INJURY OR DROWNING, DO NOT USE HYDROMASSAGE BATHTUB UNLESS ALL SUCTION GUARDS ARE INSTALLED TO PREVENT BODY AND HAIR ENTRAPMENT. WARNING: TO AVOID INJURY, EXERCISE CARE WHEN ENTERING OR EXITING THE HYDROMASSAGE BATHTU B.
Important Notes 1. Never lift a whirlpool bathtub by the pipes! By doing this you can cause severe damage to the whirlpool system. Always lift the unit by the frame to avoid the risk of any damage to the unit or the whirlpool system. 2. Before installation cover all of the jets and suction to minimize the chance of debris falling into them and creating a blockage. 3. Cover the door drain located at the bottom of the door opening with tape to avoid blocking it with debris. 4.
ELECTRICAL CONNECTIONS DANGER: Risk of severe injury from electric shock or death by electrocution. This bath must be must be connected directly to a dedicated 120V 20 amp supply circuit that is protected by a Ground Fault Circuit Interrupter (GFCI) installed by a qualified, licensed electrician in accordance with national electric and local codes and the GFCI manufacturer’s instructions. The GFCI should be tested regularly. To test the GFCI, push the “TEST” button.
Page 6 Signature Bath is not responsible for damage when holes are
7 Page Door Drain Assembly
Page 8
Page 9
Page 10
Drain Stopper Adjustment Step 1. Lift the drain stopper out of the drain. Step2. Locate the lock nut as shown in figure 1 Step 3. Loosen the lock nut as shown in figure 2 Step 4. Turn the adjusting bolt in or out to the desired height. Step 5. Tighten the lock nut. Page 11 Step6. Insert the stopper back into the drain.
SIGNATURE BATH MANUFACTURER’S LIMITED WARRANTY for Walk-In Series Baths Warranty Coverage Throughout this document, Signature Bath shall be referred to as the “MANUFACTURER”. The following expressed limited lifetime warranty is given to the original consumer of a Luxury or Luxury Plus Series Signature Bath purchased for personal or single family residential use. Any commercial applications are excluded from all warranties.
Thank you for purchasing this Signature Bath. We know you'll enjoy the relaxation, comfort and security of your walk-in bath for many years to come. Our Commitment to Quality Signature Baths are hand-crafted using the finest parts and materials available.