User's Manual

Table Of Contents

Settings on the unit

169

Press the Performance Pads on deck 1 (left) to change the

Demo mode setting.

The set value is indicated by which pad is lit.

1: Demo mode is switched off.

2: Demo mode starts when you don’t use the unit for 1 minute.

3: Demo mode starts when you don’t use the unit for 5 minutes.

4: Demo mode starts when you don’t use the unit for 10 minutes.

• After changing the setting, the setting is saved. While saving the setting, the

bottom row of Performance Pads on the left deck flashes. In this case, wait

until these pads change from flashing to lit. If the USB cable is disconnected

while the pads are flashing, the setting may not be saved.

4 Disconnect the USB cable from the device supplying power to this

unit.

Utilities mode is exited.