User's Manual

65
Advanced operation
65
— [TAP]: Press the [BEAT
c
] button while pressing the [SHIFT] button.
Enter the BPM manually. For information on manual input, refer to
Inputting the BPM manually (p. 66 ).
! The BPM measurement range for the [AUTO] setting is 70 to 180. BPM
cannot be correctly measured for some tracks. If the BPM cannot be
measured, the BPM value on the display flashes. In such cases, use the
[TAP] button to input the BPM manually.
2 Rotate the [BEAT FX SELECT] control.
Selects the type of effect.
! For information on the types of effects, refer to Types of BEAT FX
(p. 66 ).
3 Rotate the [BEAT FX CH SELECT] control.
Selects the channel to apply the effect to.
— [SAMPLER]: Applies the effect to the sound of [SAMPLER] of rekordbox.
— [1] to [4]: Applies the effect to the sound of each channel. Only [1] and [2]
are enabled when 2-channel mixer mode is set.
— [MASTER]: Applies the effect to the sound of the [MASTER] channel.
4 Press the [BEAT c, d] button.
Set the beat fraction to synchronize the effect sound with.
The effect time corresponding to the beat fraction is set automatically.
5 Press the [BEAT FX ON/OFF] button.
The effect is applied to the sound.
The effect’s quantitative parameter can be adjusted by turning the
[BEAT FX LEVEL/DEPTH] control.
The [ON/OFF] button flashes when the effect is on.
! Press the [ON/OFF] button again to turn the effect off.
Note
The effect cannot be applied to the AUX sound.