User Manual

En
10
Connections
! Connect the power cord to a power outlet after all the connections are completed.
! Turn off this unit and disconnect the power cord from the power outlet before connecting components or changing the connections.
! Refer to the operating instructions for the components to be connected.
! Be sure to use the supplied power cord.
! Connect this unit and the computer directly using the included USB cable.
Connecting input/output terminals
Rear panel, front panel
1 62 3 4 5 7 7 9
a
b
8 c
R
L
R
L
R
L
R
L
L
R
R
L
Headphones
Power amplifier,
powered speakers,
etc.
Power amplifier,
powered speakers, etc.
Power amplifier
(for booth monitor)
DJ
software
Computer
Portable audio device
DJ player
DJ player
Analog player
Microphone
Microphone
To power outle
t
Power cord
Front panel
Rear panel
To power outle
t
Power cord
1 PHONES terminals
2 MASTER1 terminals
! Be careful not to accidentally insert the power cord of
another unit to [MASTER 1] terminal.
! Do not connect the terminal that can supply phantom
power to the [MASTER 1] terminal.
3 MASTER2 terminals
4 BOOTH terminals
5 Kensington security slot
6
USB terminal
This product satisfies electromagnetic noise
regulations when it is connected to other equipment
through shielded cables (with Ferrite-cores attached)
and connectors.
Use only the furnished accessory connecting cables.
D44-8-1-2b_A1_En
The ferrite-cores are for the purpose of preventing
electromagnetic noise, do not remove them.
D44-8-1-4_A1_En
7 LINE/PHONO terminals
8 AUX terminal
9 SIGNAL GND terminal
a MIC2 terminal
b MIC1 terminal
c AC IN