User's Manual
Table Of Contents
- How to read this manual
- Before you start
- Connections
- Part names and functions
- Operation
- Turning the power on
- Turning the power off
- Connecting and disconnecting USB devices
- Playing tracks
- Outputting sound
- Using the Quantize function
- Calling up settings stored on a USB device connected to the unit
- Changing the color set in the USB device connected to the unit
- Changing the settings
- Auto play mode
- Auto standby setting
- Talkover function
- Language settings
- Correcting deviation in the touch display calibration
- Setting preferences
- Using DJ software
- Additional information
Part names and functions
47
En
Setting loops
You can choose the section you want to loop.
The loop playback interval can’t be set for a previous or next track.
• When the Quantize function is turned on, you might notice a slight
delay due to quantization.
1 Press the [LOOP IN/CUE (IN ADJUST)] button at the point you
want to start looping (the Loop In Point) during playback.
This operation isn’t necessary if you want to set the currently set cue point as
the Loop In point.
2 Press the [LOOP OUT (OUT ADJUST)] button at the point you
want the loop to end (the Loop Out Point).
The loop playback starts.
Fine-tuning the Loop In point (Loop In Adjust)
1 During loop playback, press the [LOOP IN/CUE (IN ADJUST)]
button.
The [LOOP IN/CUE (IN ADJUST)] button starts flashing rapidly, and the
[LOOP OUT (OUT ADJUST)] button turns off.
The time of the Loop In point is displayed on the main unit display.
2 Press the [SEARCH , ] button.
The Loop In point can be adjusted in units of 0.5 frames.
• The same operation is possible using the jog wheel.
• The Loop In point’s range of adjustment is ±30 frames.
• The Loop In point can’t be set beyond the Loop Out point.
3 Press the [LOOP IN/CUE (IN ADJUST)] button.
Loop playback resumes.
• Normal loop playback also resumes if no operation is performed for over 10
seconds.