User's Manual

Part names and functions
53
En
 Setting Hot Cues
1 Press the [HOT CUE (CALL)] button to switch to Hot Cue mode.
2 During playback or while paused, press one of the Performance
Pads at the point at which you want to set a Hot Cue.
The point is set as a Hot Cue, and the Performance Pad lights up. The setting
is stored on the USB device at the same time.
• During loop playback, the loop is registered as a Hot Cue.
• The direction of playback isn’t recorded for Hot Cues.
• When a Hot Cue is set during scratch play, playback may stop temporarily.
• When the Quantize function is turned on, you might notice a slight delay due
to quantization.
• A Hot Cue can’t be stored when a Hot Cue has already been stored in the
Performance Pad. To store a new Hot Cue, delete the stored Hot Cue.
 Playing Hot Cues
During playback or pause, press one of the Performance Pads.
The Hot Cue stored on that button is called up and playback begins.
The information of the loop playback stored in a Performance Pad is
different from the loop playback set by using the [LOOP IN/CUE (IN
ADJUST)] and [LOOP OUT (OUT ADJUST)] buttons.
• After the loop stored in the Performance Pad is called up, you can
cancel loop playback by using the [RELOOP/EXIT] button. You can
also fine-tune the Loop In point by using the [LOOP IN/CUE (IN
ADJUST)] button or the Loop Out point by using the [LOOP OUT
(OUT ADJUST)] button.
• After adjustment, the information stored in the Performance Pads
changes.