User Manual
Table Of Contents
- Before starting the procedure
- Speaker Layout
- Speaker Installation
- Speaker Connections
- Connections
- Playback
- Playing audio from an externally connected device
- BLUETOOTH® Playback
- Listening To the Radio
- Listening Mode
- AV Adjust
- Spotify
- AirPlay®
- DTS Play-Fi®
- Amazon Alexa
- Amazon Music
- TIDAL
- Connecting the Sonos System for Playback
- Internet Radio
- Multi-zone
- Using PERSONAL PRESET
- Playing music files saved on a USB storage device
- Music Server
- Play Queue
- Connecting a transmitter for playback
- Setup
- Troubleshooting
- Appendix
7.1c h
5.1. 2c h
5.1c h
7.1. 2ch
5.1.4ch
33
Speaker Connections
Speakers you can use with this unit and cable connections
Speakers you can use with this unit
This unit supports speakers with 4 Ω to 16 Ω impedance. For speaker impedance, check the speaker instruction manual.
(Note) Speaker Impedance
If any of the speakers to be connected has an impedance of 4 Ω or more and less than 6 Ω, set "Speaker Impedance" to "4ohms" for "Speaker Setup" in the Initial
Setup section ( →p147). When setting "Speaker Impedance" from the System Setup menu, press the button on the remote controller to display the Home
screen, and select "System Setup" - "Speaker" - "Conguration", then set "Speaker Impedance" ( →p115) to "4ohms".
Connect the Speaker Cables
1/2˝
(12 mm)
Make correct connection between the unit's jacks and speaker's jacks (+ side to + side, and - side to - side) for each channel. If the connection is wrong, a bass
sound will not be reproduced properly due to reverse phase. Twist the wires exposed from the tip of the speaker cable so that the wires do not stick out of the
speaker terminal when connecting. If the exposed wires touch the rear panel, or the + side and - side wires touch each other, a malfunction may occur.